The intelligent control aluminum profile extrusion press machine plant line now used, in which the feed funnel is installed at the middle top of the frame, the feed screw is arranged at the lower side, a horizontal silo is set below the feed screw, the discharge port of the leveling silo is connected with one end of the baffle, the other end of the baffle extends into the die tube assembly, the two ends of the die tube assembly are respectively connected with the lifting cylinder, the lower end passes through the sliding block, and the punch group extends to the middle of the two hot pressing plates, A stainless steel protection plate is also arranged inside the hot pressing plate, which is fixed by the pressure cylinder group.

The slider punch group of the aluminum profile extrusion press machine plant line is connected with one end of the connecting rod, and the other end of the connecting rod is connected with the rotating crankshaft. The rotating crankshaft is connected through a belt to drive the motor. The hollow particleboard aluminum profile extrusion press machine plant line has reasonable structure, high precision and good uniformity. Therefore, the aluminum profile extrusion press machine plant line is composed of mechanical parts and transmission pressing parts, mainly composed of extrusion rod and fuel tank. The mechanical part of the aluminum profile extrusion press machine plant line is composed of columns, The transmission pressing part of the aluminum profile extrusion press machine plant line includes the inner and outer sides of the front and rear beams, which are respectively provided with nut fasteners.

The current aluminum profile extrusion press machine plant line equipment has the advantages of simple structure, new transmission mode, multiple transmission capacity magnification, effective reduction of energy consumption, compact structure, small volume, small impact vibration and low impact noise. Nowadays, the twin-cylinder screw plastic aluminum profile extrusion press machine plant line includes a feeding cylinder, the upper part of the feeding cylinder is connected with the cooler, and the temperature sensor is set in the cooling

The cooler is equipped with a high-frequency vibrator, and the upper part of the cooling device is connected with the feed inlet. Because the bottom of the feed inlet of the aluminum profile extrusion press machine plant line is provided with a baffle, the pipeline is juxtaposed with two screws, the pipeline is provided with an electromagnetic heater, the pipeline is provided with a temperature sensor, the bottom of the pipeline is close to the side of the cooler, the outer layer is provided with a gravity sensor, and the outer layer is outside the barrel. The current aluminum profile extrusion press machine plant line equipment disperses the materials entering the barrel to prevent the materials from accumulating in the front of the barrel, and the iron chips and impurities in the iron chips can be removed, Materials and purification materials.