In southern cities, although winter is not cold, its coldness is quite piercing and can last for a long time. Both humans and mechanical equipment are affected by this. The pipe bending machine has many problems in winter, and these problems often occur. Many machines and equipment will encounter a phenomenon of not being able to start or not being able to start. If this situation occurs frequently, it will not have a good impact on this device. In summer, the entire equipment will feel very relaxed and no longer have to bear anything else. Now, let's take you through the measurement methods for identifying the quality of pipe bending machines.

The hardness of the mold base and mold is also crucial for the normal use of the equipment in the future. When the hardness of the mold seat is lower than Rockwell hardness 60 and the hardness of the mold is lower than Rockwell hardness 50.

2. The main parameters of the measuring equipment: let the equipment idle, touch each module with your hand, and the touch should not shake, otherwise it will be considered as unqualified products.

3. Place the equipment on the mold, buckle a sample joint, and measure the buckle joint with a caliper or micrometer. Roundness of 0.1MM is considered excellent.

4. Check the eight lobe average division of the equipment mold base and the flatness of the mold. Good equipment will specifically control and adjust these two parameters, while some inferior equipment will not control these two parameters.

The most widely used is the fully automatic pipe bending machine. However, friends who have used it know that the wear rate is high, so how can we reduce this wear rate?

Imported railway lines should be added with new lubricating grease every week. Clamp the high-temperature lubricating grease of the oil cylinder bearing and inject it every 1-2 weeks.

The remaining bearing lubrication of the automatic pipe bending machine should be cleaned once a year. The front and rear automatic bending spindle bearings are suitable for high-speed grease opening and mechanical sealing without feeding. The fully automatic pipe bending machine and pipe cutting machine at the front should be kept clean, and the dust covers of the front and rear rails should be intact. In addition to the five methods mentioned above, there are also many other methods that can reduce wear and tear.

Wonsten china cnc pipe bending machine automatic tube bender factory specialized in producing pipe bending machines