Hydraulic pipe bender daily operation power and full precautions and the correct steps for adding lubricating oil to the pipe bender
time2023/09/14
- The use method of hydraulic pipe bending machine is very simple, and some issues should be paid attention to when using it
The use method of hydraulic pipe bending machine is very simple, and some issues should be paid attention to when using it, such as power safety, because electricity is not a small matter, and improper use can cause serious consequences.
1. Although the circuit of the hydraulic pipe bending machine is insulated, there will always be circuit interfaces. Do not touch them, and of course, do not allow people to touch them. Only professional personnel can touch them during maintenance or other situations.
2. The voltage provided by the pipe bending machine must be based on the voltage used by the pipe bending machine, and cannot be overloaded, which is very dangerous and may cause machine damage, shutdown, or even leakage.
3. Before any electrical box is opened, the machine must be isolated from the power supply. The power should be turned off.
When using hydraulic pipe bending machines, Z is very important in terms of electrical safety. The correct use of electricity is a guarantee of Z safety, whether it is a machine or a worker.
During the use of the pipe bending machine, lubricating oil is inseparable, and if there is a lack of lubricating oil, it will affect normal use. Of course, when adding lubricating oil, we must master the correct method
Firstly, before adding lubricating oil, it is necessary to clean the oil tank, remove internal impurities, and pay attention to the oil filter screen to see if there are any defects. It is necessary to pay attention to the inspection work, only in this way can the lubricating oil be added smoothly.
Secondly, when adding lubricating oil, it is not advisable to add too much, just add it to the standard to ensure its good use effect.
When adding lubricating oil to the pipe bending machine, it is necessary to master all the above aspects. Only in this way can this work proceed more smoothly and have a good maintenance effect on the equipment itself.